Lighthouse ActiveCount100 Operating Manual
248083444-1 Rev 2 P a g e 17 of 40
Np 6
Security Screen
Security
OK
Configuration Lock
MYPWD
Edit Password
MYPWD
H
O
New Password
1 2 3
4 5 6
A B C D
GE F H
7 8 9
0_
I
J
K L
M N O P
Q R S T U
V W YX Z
#
Enable/Disable
Current Password Edit Password
Sample
Delay
Volume
00:20:00
1000 L
00:00:30
Config Screen
Mode Periodic
Cycles 5
Security
00:17:45
Main Screen
79%
02/26/2015
LOC00112:45:30 PM
49.0 L
00:05:30
4/10
USER001
1000L
Config Password
MYPWD
H
O
Password
1 2 3
4 5 6
A B C D
GE F H
7 8 9
0_
I
J
K L
M N O P
Q R S T U
V W YX Z
#
Sample
Delay
Volume
00:20:00
1000 L
00:00:30
Config Screen
Mode Periodic
Cycles 5
Lock Icon
Security: Configuration Lock
ActiveCount100 Sampling Modes can be restricted by locking the Configuration Screen. Before
locking the configuration screen; select the sample mode and sample settings to be locked.
Configuration Lock: With the configuration screen locked; users are restricted to the preselected
sample mode (Constant/Periodic/Gas). The user may not select any other sample mode and may
not change any sample parameters. The user may run the selected sample only.
- From the Home screen press Configuration and then press the LOCK icon button. This will
bring up the Security screen.
- Press the Edit Password button (pencil icon) to bring up the New Password screen
- Enter the new password and press the return key to save and return to the Security
screen.
- Slide the Configuration Lock toggle button to the right for ON or to the left for OFF.
- Press OK to save the Security Settings.
To Next Page
Loading...