DEUTSCH ENGLISH FRANCAIS ESPAÑOL
23
DEUTSCH ENGLISH
Display settings
1. Language: This menu subsection allows you to select the language between Chinese
and English.
2. Screen Saver: If the display is not used for more than 10 seconds, it switches to Saver mode.
Modus 1: Display turns off when it is not needed
Modus 2: Display shows the DMX address (in DMX mode) or the selected mode
(Auto Run or Sound Ctrl).
Off: Display light remains on, display shows the main menu.
3. Screen Rotation: Under this menu subsection the display can be rotated (overhead mounting,
standing installation)
4. Touch enable: Under this menu subsection, the touch function of the display can be
activated and deactivated.
5. Touch Adjust: The touch screen can be adjusted under this menu sebsection.
Test mode
PAN: Range 0 - 255 Gobo: Range 0 - 255
Tilt: Range 0 - 255 Prism: Range 0 - 255
Focus: Range 0 - 255 Frost: Range 0 - 255
Color: Range 0 - 255 Strobe: Range 0 - 255
Adjust the spotlight parameters
Pan Invert: Invert the PAN movement
Tilt Invert: Invert the TILT movement
Rectify enable: Enables or disables automatic position correction
Pan Offset: Moves the spotlight to the PAN home position
Tilt Offset: Sets the spotlight to the TILT home position
Lamp on when: The „Lamp On“ mode includes 3 modes: Power on, after reset and manual
Factory Setting: All settings are reset to the factory settings
Device status
Under this menu subsection you can see the currently installed software as well as reset the DMX
data to ‚0‘ (DMXClr) and reset the device (SysRst).
To Next Page
Loading...
Need help?
General
