LightSpeed Technologies Zulu - Lightspeed Zulu Bluetooth Devices; Connecting Bluetooth Cell Phones First Time

13
Zulu’s Bluetooth interface allows cell phone and
stereo music streaming capability (A2DP).
Connecting Bluetooth Cell Phones for the
First Time
Before using a Bluetooth cell phone for the
rst time with Zulu it must be “paired” or
electronically connected.
To pair a Bluetooth cell phone with Zulu:
1. TurnontheheadsetandverifytheGREENLED
is ashing. Make sure Zulu’s Bluetooth mode
isturnedOFF.BLUEorREDashesfromthe
Bluetooth LED should not be present (see
“Bluetooth Mode—ON and OFF”, page 14).
2. Press and hold the Zulu Bluetooth button
for about ve to ten seconds or until the
Bluetooth LED continually ashes RED and
BLUE. This indicates the Zulu pairing mode
setting and lasts about two minutes. If this
step takes longer and the Bluetooth LED is no
longeralternatingREDandBLUE,startover
from step one.
3. With Zulu in pairing mode, follow the menu
prompts on your Bluetooth phone directing
it to look for Bluetooth devices.
4. SelectLightspeed-V###(numbersmayvary)
on your Bluetooth phone from the list of
found devices
5. If asked to enter a password or PIN, enter 0000
Bluetooth Devices