23
2. Daily Operation
3. Optional
Accessories
1. Overview 4. Troubleshooting
5. Warranty, Safety
& Specifications
USING THE REDMIKE VC TO AMPLIFY
EXTERNAL AUDIO EQUIPMENT
The REDMIKE VC includes a 3.5mm audio input jack to connect to an audio
source like a laptop or MP3 player. The REDMIKE VC will transmit the audio
signal to be played through the system.
If your system includes two REDMIKE VCs, we recommend using channel B
(student mike) to amplify the external audio equipment so the teacher’s volume
on the channel A (teacher mike) does not have to be adjusted.
To determine which REDMIKE VC is set to channel B, you can look at the label or
switch on the back of the microphone.
1. Adjust the volume of your laptop
or MP3 device to about 25% of
maximum.
2. Plug your external audio equipment
(for example, laptop), into the input
on the REDMIKE VC labeled “INPUT”
using a 3.5mm patch cable.
2. Adjust the volume of the REDMIKE
VC or audio source to achieve desired
loudness.
NOTE: turning up the volume too
high on the audio source can cause
excessive distortion in the audio.
AUDIO
OUTPUT
AUDIO
INPUT
To Next Page
Loading...
