Need help?Do you have a question about the Limitorque SMB-2 and is the answer not in the manual?
General| Brand | Limitorque |
|---|---|
| Model | SMB-2 |
| Category | Controller |
| Language | English |
Explains the manual's scope covering installation, operation, disassembly, lubrication, and parts.
Details precautions to reduce injury and equipment damage, including warning symbols.
Instructions for receiving, inspecting, and storing the actuator to maintain integrity.
Details information found on actuator and motor nameplates for identification.
Procedures for inspecting the actuator upon receipt and recording its details.
Recommended storage procedures to maintain product integrity and avoid warranty voidance.
Critical warnings and precautions for safe installation, operation, and troubleshooting.
Checkpoints for safe operation, including mounting, cleanliness, and wiring verification.
Steps to prepare the actuator for installation, including replacing protectors and checking mounting.
Procedures for setting the limit switches to trip at desired valve positions.
Procedures for setting the torque switch to protect the actuator from overload.
Instructions for setting local and remote position indicators.
Information on electrical components like reversing starters and overload relays.
Explains how the actuator operates using the electric motor and its internal mechanisms.
Instructions for operating the actuator manually using the handwheel.
Procedures for regular maintenance checks every 18 months or 500 cycles.
Procedures for major maintenance when operational deficiencies are evident.
Guidance on lubricating the actuator's components for optimal performance.
Disassembly and reassembly instructions specific to the SMB-000 model.
Disassembly and reassembly instructions specific to the SMB-00 model.
Disassembly and reassembly instructions for SMB-0, 1, 2, 3, 4, and 4T models.
Disassembly and reassembly instructions for SMB-5 and SMB-5T models.
Disassembly and reassembly for the SB-00 actuator, referencing SMB-00 procedures.
Disassembly and reassembly for the SB-0 actuator, referencing SMB-0 procedures.
Disassembly and reassembly for the SB-1 actuator, referencing SMB-0 procedures.
Disassembly and reassembly for the SB-2 actuator, referencing SMB-2 procedures.
Disassembly and reassembly for the SB-3 actuator, referencing SMB-3 procedures.
Disassembly and reassembly for the SB-4 actuator, referencing SMB-4 procedures.
Corrective actions for when geared limit switches fail to stop valve travel.
Corrective actions for when the actuator cannot be operated by motor.
Corrective actions for when excessive effort is required to turn the handwheel.
Corrective actions for starter and pushbutton contact issues.
Details required information for ordering parts or obtaining further information.
Table showing space heater sizes based on voltage rating for limit switch compartments.
Formal declaration of conformity to applicable EU directives and standards.
To Next Page
