What to do if Linak LA31 Controller control box is okay, except for one direction on one channel?
If the control box is generally okay but has a problem with one direction on one channel, send the control box for repair, as it is likely defective.
Why power indicator does not light up on Linak Controller?
If the power indicator on your Linak Controller doesn't light up, start by ensuring it's connected to the mains. If it is, check the fuse; replace it if the system allows external fuse replacement. A defective power cable could also be the issue; if the cable is exchangeable, try a new one. If not, or if the control box is defective, the unit needs repair.
How to fix motor that runs too slowly on Linak Controller?
If the motor on your Linak Controller runs too slowly or lacks full force, the issue might be an insufficient power supply; try increasing it. Alternatively, a voltage drop in the cable could be the cause, necessitating a thicker cable.
Why Linak Controller control box is completely dead on battery?
If the control box of your Linak Controller is completely dead on battery and there's no relay clicking, the battery might be completely flat; try charging it. If charging doesn't help, the battery may be defective and needs replacement.
What to do if no relay noise is heard from Linak Controller control box?
If you hear no relay noise from the control box, send the hand control for repair as it may be defective.
Why can't my Linak LA31 actuator lift the full load?
If the actuator cannot lift the full load, send the actuator for repair. The clutch may be worn, or the motor may be damaged.
What to do if there is motor sound but no movement of piston rod in Linak Controller?
If you hear the motor running but the piston rod isn't moving, send the actuator for repair.
Why is the Linak LA31 control box completely dead on battery with no relay clicking?
If the control box is completely dead when running on battery and there's no relay clicking, it could be: * The battery is completely flat, so charge it. * The battery is defective and needs replacement.
How to fix Linak LA31 when there is no motor sound or piston rod movement?
If your Linak Controller exhibits no motor sound and the piston rod doesn't move, here are a few things to check: * Ensure the actuator is properly connected to the control box; if not, connect it. * Check the fuse in the control box and replace it if it's blown. * If the cable is damaged, send the actuator for repair.
What to do if motor runs but spindle does not move on Linak Controller?
If the motor runs but the spindle does not move on your Linak Controller, it is likely that the gear wheel or spindle is damaged, requiring the actuator to be sent for repair.
General| Brand | Linak |
|---|---|
| Model | LA31 |
| Category | Controller |
| Language | English |
To Next Page
