Linar Model 10 Multi-channel Integrated Amplifier 12
Specifications
Power Output:
120 Watts into 5 channels at 8 ohms
200 Watts into 5 channels at 4 ohms
300 Watts into 5 channels at 2 ohms
Total Harmonic Distortion 20Hz-20kHz: Typical 0.05% (worst case 0.4%)
Total Intermodulation Distortion: Typical 0.05% (Note 1)
Noise: 110 db below maximum rated power.
Frequency Response: 1Hz-250 kHz +0-3db
Power Supply: 1500 VA (2x750) Custom Made Plitron Toroidal Transformers
Input Impedance: 35 kΩ
Output Impedance: 0.016 Ω
Damping Factor: Better than 500
Input sensitivity: RCA inputs 0.35 Volts RMS (for max power)
Gain: 90 times the input signal
Channel separation: > 100db
Slew rate: N/A (Note 2)
Class of operation: A, AB
Power consumption at idle: 30.5 watts
Mass: 65 lbs with packaging (30 kg)
Dimensions: 18” x 7.25” x 16” (LxHxD)
Note1 - According to IHF-A202 standard, for the purpose of this standard F1 shall equal 60hz and
F2 shall equal 7000hz, the low frequency sine wave having an amplitude 4 times greater than
that of the high frequency sine wave. The measurements of Linar amplifiers are in respect of this
standard but with any frequency combination in any ratio.
Note 2 - The amplifier has no global feedback making the slew rate irrelevant.
To Next Page
Loading...