Linar Model 10 Multi-channel Integrated Amplifier 9
Remote Control Functions
Your Linar Model 10 is shipped with a convenient
remote control unit. In addition to the previously
described functions, the remote control also has the
following uses:
Power On/Off
Press the POWER button to switch your amplifier from
its standby state to its full operating mode. Press the
POWER button again to return the amplifier to standby.
Volume Controls
The REAR VOL button allows you to switch the volume
control between the main channels, the rear channels,
and the subwoofer. See Volume Settings section for
complete details
Stereo in 4-Channel
Pressing the ST IN 4 CH button will enable the Stereo
in 4 Channel function. This function feeds the music
signal from the front channels to both the front and rear
channels. See Operating Modes section for complete
details.
Mute
Pressing the MUTE button on your remote control will
reduce the output level of your amplifier to a barely
audible level. Pressing the MUTE button again will
return the amplifier to its previous volume setting.
Display
Pressing the DISPLAY button will turn off the
illumination of the front control panel of your Linar
amplifier. Pressing the DISPLAY button again will turn
the illumination back on.
CD/TUNER/AUX1/AUX2/AUX3
Pressing these buttons will select the listening sources
you have connected to the corresponding inputs of
your amplifier.
Figure 3. Remote Control
To Next Page
Loading...
Need help?
General