Linar Model 10 Multi-channel Integrated Amplifier 8
Power On/Off
Use the Power button to turn your Linar multi-channel amplifier on or off. Press
the button once to turn the power on, and press again to turn the power off.
Monitor
Pressing the MONITOR button will select the TAPE input of your Linar Model 10.
At the same time, the signal from your selected source will be fed out via the
TAPE OUT at the rear of the amplifier. The monitor function can be used to listen
to a source connected to the TAPE IN, or to monitor a recording as it is occurring.
The monitor function can be turned on or off with the remote control, allowing
direct comparison of original and recorded media from your listening position.
The Tape Loop can also be used for surround processors.
Volume
The Volume Up and Down buttons on the faceplate of your amplifier control the
output level (Gain) of your Linar amplifier. All channels, including the subwoofer,
will increase or decrease when these volume controls are operated. 2 horizontal
bars in the display window indicate volume levels. Each bar has a maximum of
32 segments, representing a total of 32 individual volume settings. The slight
clicking noise that can be heard when adjusting the volume is normal. Each click
represents one of the 32 distinct volume levels. The clicks are due to the
microprocessor that controls the volume. There are no moving parts in the
volume control system, resulting in both superior sound and extended lifespan.
The overall volume can be adjusted by pressing the VOL and buttons on the
remote control. Refer to the Volume Settings section for complete details.
To Next Page
Loading...
Need help?
General