Linar Model 10 Multi-channel Integrated Amplifier 6
Outputs: Line-Level Connections
Your Linar Model 10 has 2 sets of single-ended. These are labelled TAPE OUT
and SUB OUT. The TAPE OUT is for connection to a cassette deck or other
recording device. The SUB OUT is for connection to one or two subwoofers. For
Stereo inputs (i.e. CD, Tuner, etc.), the left and right channels are combined,
giving a mono output from the SUB OUT. For your 5.1 channel source, the mono
input signal is passed through to both the left and right SUB OUT. A single
subwoofer can be connected using either the left or right SUB OUT. If you have
two subwoofers, connect one subwoofer to each of the left and right SUB OUTs.
Outputs: Speaker Connections
Your Linar Model 10 multi-channel amplifier is supplied with 5 separate speaker
connections. There are Left and Right Front Output Speaker connections, Center
Output Speaker connections, and Left and Right Rear Output Speaker
connections. Ensure you connect the correct speaker to the correct output for
proper system performance. Follow each speaker wire from the amplifier to the
appropriate speaker to make certain you have connected them properly. The
+
outputs are coloured red and the – outputs are coloured black. Ensure all +
outputs from the amplifier match the + inputs of your speakers so you will not
encounter phase problems.
The speaker outputs will accept most common wire connectors, including banana
plugs, spades, and bare wire. Under no circumstances should your speaker
cables be allowed to short-circuit the amplifier by contacting the + and – outputs
simultaneously.
Power Connection
Your Linar Amplifier has an “IEC” type AC power connector. Insert the supplied
AC power cord into connector prior to plugging the cord into the AC wall
receptacle.
To Next Page
Loading...
Need help?
General