IS726 ECN 4530 Page 7 of 10
Insert the new filter into the recess and lock in place by twisting to the right.
Press the “Filter life icon” and follow the on-screen instructions to reset the filter life.
Drain off approximately 5 litres of water to remove any loose carbon particles from the
filter.
The boiler will not fill if the filter is removed as the filter head incorporates a shut-off
valve.
F10-Chiller condenser over heat: This could be due to condenser fan not working,
condenser air outlet blocked or condenser blocked.
F11-Chiller- clean condenser: This is a regular periodic warning to ensure the condenser
fins are not blocked that should be kept clean to ensure optimum operation of cooler water
cooling system.
CLEANING
Do not use a water jet or steam cleaner, and do not immerse this appliance.
Clean all panels with warm water and mild detergent and do not use abrasive
materials. Dry with a soft cloth.
Slide out and empty the drip tray regularly, and wipe the dispensing tap spouts daily
to remove limescale deposits.
SPARES LIST
Part number Description
PR111 Control/Display board
PR101 Auxiliary power board
PR100 Power board
TH88 Tank over heat cut out
TH123 Steam/over flow over heat cut out
TH124 Hot tank thermistor
TH126 Cold block thermistor
WL13 Level sensor cable
CA179 Interconnect data cable
CA207 Condenser signal cable
EBCM01 Chiller module
To Next Page
Loading...
