What to do if my Lincoln 1800 Lubrication systems PowerLuber fails to dispense grease?
If your Lincoln Lubrication system's PowerLuber isn't dispensing grease, here's what you can check: * Make sure the grease tube assembly isn't empty. * You may have lost prime; try repeating the priming operation. * Inspect the ball check (item 19). Remove it, then clean and inspect the ball seat area.
Why does the motor of my Lincoln 1800 fail to run?
If the motor of your Lincoln Lubrication systems fails to run, here are a few things to investigate: 1. The battery might need charging; recharge it. 2. There could be faulty wiring to the motor. Remove the battery, disassemble the handle, and check the wiring for any loose connections. 3. The circuit breaker might have tripped; reset it.
What to do if the battery of my Lincoln Lubrication systems fails to take a charge?
If the battery of your Lincoln Lubrication systems fails to take a charge, consider these possibilities: * The charger may not be getting power. Check that the receptacle has power. * The battery itself might be faulty. If so, replace it.
How to fix a Lincoln 1800 PowerLuber that continues to lose prime?
If your Lincoln Lubrication systems PowerLuber continues to lose prime, consider the following: * Air may be trapped in the container after bulk filling. Empty the grease tube assembly, refill it, and then repeat the priming instructions. * The follower might be binding in the grease tube assembly. You can replace the grease tube assembly (Item 2), disassemble and clean the grease tube assembly, ensure the follower has properly entered the grease cartridge, or verify that the follower is not caught on the rim of the grease cartridge.
General| Brand | Lincoln |
|---|---|
| Model | 1800 |
| Category | Lubrication systems |
| Language | English |
Keep work area clean, avoid explosive atmospheres, and keep bystanders away.
Ensure correct plugs, avoid body contact with grounded surfaces, protect from moisture, and do not abuse cords.
Stay alert, use PPE, prevent unintentional starting, and remove adjustment tools.
Maintain footing, dress properly, use dust extraction, and keep clear of moving parts.
Use correct tool, ensure switch works, disconnect power, store properly, maintain tools, and use as intended.
Always wear eye protection; use specific Lincoln hoses and handle them by the spring guard.
Prevent unintentional starting and replace worn or kinked hoses immediately.
Read all instructions, use correct chargers/batteries, protect from elements, and do not abuse cords.
Solutions for motor not running, grease not dispensing, or loss of prime.
To Next Page
