EasyManua.ls Logo

Lincoln Quicklub Series - User Manual

Lincoln Quicklub Series
6 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Lincoln Quicklub System Operation
and Troubleshooting Guide
System Operation
The key components of the Quicklub system are:
1. Pump with integrated system control and monitoring
2. Proximity Switch
3. Divider valve network consisting of a Primary Valve and Secondary Valves
4. A lubrication event is initiated by actuating the pump via the integrated controller based
on a preset “pause time” or time between lubrication events.
5. The Pump dispenses lubricant to the primary divider valve
6. The Primary Valve distributes the lubricant to the secondary valves
7. The Secondary Valves distribute and dispense lubricant to the lubrication points.
8. Lubricant flow through the divider valves actuates the Proximity Switch, which sends a
signal back to the integrated controller/monitor acknowledging proper system operation
and turning off the pump.
9. The controller now begins countdown for the next lubrication event.

Questions and Answers

  • J
    Jimmy WhiteJul 28, 2025
    What to do if Lincoln Lubrication systems pump motor runs continuously?
    • Q
      qandersenJul 28, 2025
      If the pump motor in your Lincoln Lubrication system runs continuously, several issues could be the cause. First, the proximity switch might be defective, in which case you should disconnect the main line leading to the monitored metering device. Check the cable connections to the pump and replace the proximity switch with the connector if necessary. Other potential causes include a defective printed circuit board (replace it), a blocked grease line (clear the blockage), an empty reservoir (refill it), air in the system (purge the air), or a broken supply line to the divider valve with Proximity switch (repair the supply line).
  • P
    pricemichaelAug 11, 2025
    How to troubleshoot Lincoln Lubrication systems when the pump motor does not run?
    • M
      Martin EdwardsAug 12, 2025
      If the pump motor of your Lincoln Lubrication systems isn't running, start by checking the voltage supply to the pump and fix any issues. Then, inspect the line from the pump plug to the printed circuit board for interruptions. If these steps don't resolve the problem, the printed circuit board may be defective and require replacement.

Summary

System Operation

System Troubleshooting

Pump Motor Not Running Fault

Details causes and remedies for the pump motor failing to run.

Continuous Pump Motor Operation Fault

Details causes and remedies for the pump motor running continuously.

Locating Blockage in Lincoln Quicklub Systems

Blockage Identification and Inspection

Identifies common causes of blockages and outlines inspection steps.

Blockage Diagnosis Procedure

Provides step-by-step instructions for diagnosing and locating blockages in the system.

Contamination as a Blockage Cause

Explains how contamination leads to blockages and the necessary corrective actions.

Grease Separation Blockage Issues

Describes blockages resulting from grease separation and their resolution.

Lincoln Quicklub Series Specifications

General IconGeneral
BrandLincoln
ModelQuicklub Series
CategoryLubrication systems
LanguageEnglish

Related product manuals