Recalling a Memory Position with the Remote Control
The memory positions are also recalled when you press unlock on your
remote control (if the transmitter is programmed to a memory position)
or, when you enter a valid personal entry code that is programmed to a
memory position. If the easy entry feature is enabled, the seat will first
move to the easy entry position. The seat will move to the final position
when the key is in the ignition or when the push button start system is
put in accessory mode/started.
To program the memory feature to a remote control, refer to Keys and
remote control.
Easy Entry/Exit Feature
This feature automatically moves the steering wheel all the way up and
in and moves the driver’s seat rearward 2 in. (5 cm) when:
• the transmission selector lever is in position N or P
• the ignition is turned off
The seat and steering wheel will move to the original position when:
• the transmission selector lever is in position N or P
• the ignition is put in accessory mode/started
The easy entry feature can be turned off or on through the vehicle
message center. Refer to the Information Displays chapter.
HEATED AND COOLED SEATS
Heated Seats
WARNING: Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes, spinal cord
injury, medication, alcohol use, exhaustion, or other physical conditions,
must exercise care when using the seat heater. The seat heater may
cause burns even at low temperatures, especially if used for long
periods of time. Do not place anything on the seat that insulates against
heat, such as a blanket or cushion, because this may cause the seat
heater to overheat. Do not puncture the seat with pins, needles, or
other pointed objects because this may damage the heating element
which may cause the seat heater to overheat. An overheated seat may
cause serious personal injury.
136 Seats
2013 MKX (mkx)
Owners Guide gf, 2nd Printing
USA (fus)
To Next Page
Loading...
Need help?
General
