Lincoln 82050 User Manual (English)

Other manuals for Lincoln 82050

Owner's/Operator's Manual8 pages

Operating Instructions12 pages

Questions and Answers:

B
benjamin04Jul 28, 2025
What to do if my Lincoln Water Pump runs continuously?
- J
  Jill McfarlandJul 29, 2025
  If your Lincoln Water Pump continues to run even when the outlet is closed, it could be due to several reasons. The material container might be empty, leading to continuous acceleration of pump cycles. Alternatively, the material supply line could be broken or leaking. Another potential cause is damaged inlet check valves in the pump tube inlet. To resolve this, first, shut off the pump and refill or change the material container. If that doesn't work, shut off the pump and check and tighten the material line. Lastly, shut off the pump, perform the pressure relief procedure, and inspect the check valve, replacing it if damaged.
R
Richard MannAug 7, 2025
What to do if Lincoln Water Pump loses pressure?
- J
  Jeffrey OwenAug 7, 2025
  If your Lincoln Water Pump is losing pressure and volume and doesn't stop operating after the material outlet is closed, it may be due to worn priming check seats in the lower part of the pump tube or check seats in the plunger. Another possibility is damaged or worn plunger rod and packing in the lower part of the pump tube. To address this, shut off the pump, perform the pressure relief procedure, disassemble the pump tube, and replace the worn check parts. Additionally, shut off the pump, perform the pressure relief procedure, disassemble the pump tube and check the plunger rod and packing, replacing them if damaged.
W
wcamposAug 12, 2025
Why is my Lincoln 82050 Water Pump running erratically?
- J
  John HarrellAug 12, 2025
  If your Lincoln Water Pump is operating erratically or accelerating with unchanged material output, it could be due to several factors. The material might be too heavy, or the pump cycles might be too fast for material intake. An increase in the material's viscosity, possibly due to a temperature drop, could also be the cause. Additionally, there might be an insufficient material supply, causing the pump to suck air. To resolve this, try reducing the air pressure to the pump. You can also heat the material to decrease its viscosity. If the material supply is low, shut off the pump and refill or change the material container.
V
vazquezlindaAug 16, 2025
How to fix air seepage in Lincoln 82050 Water Pump?
- T
  Todd WallerAug 16, 2025
  If you notice air seeping from the air exhaust of your Lincoln Water Pump when it's not operating, it could be due to a damaged valve slide and seat or gasket of the air motor. Another potential cause is damaged sealing. It can also be caused by seepage between the air cylinder and air motor head. To fix this, shut off the pump, perform the pressure relief procedure, remove the parts for inspection, and replace them if damaged. Also, shut off the pump, perform the pressure relief procedure, disassemble the air motor, and replace any faulty parts.
K
Katherine RobinsonAug 22, 2025
What to do if Lincoln 82050 leaks material?
- S
  schroederlarryAug 22, 2025
  If material is leaking from the weep hole at the bottom of the Outlet Casting of your Lincoln Water Pump, it's likely that the seals of the gland in the outlet casting are worn. To address this, shut off the pump, perform the pressure relief procedure, and disassemble the pump. Check if the gland nut is tight. Remove the gland nut and its parts, then replace the O-ring, U-cup packing, packing, and gasket. Also, inspect the piston rod and replace it if it's worn.