Declaration of Incorporation*
DOCUMENT NUMBER
404591.DoI
Manufacturer name/address:
Lincoln Industrial Corporation
N. Hanley Road
St. Louis, MO U.S.A.
TEL: + () - FAX: + () -
Authorized to compile the technical file:
SKF Lubrication Systems Germany GmbH
Heinrich-Hertz-Straße -
Walldorf, Germany
TEL: + () -
EMAIL:
robert.collins@skf.com WEBSITE:
www.skf.com
This Declaration of Incorporation is issued
under sole responsibility of the
manufacturer. Lincoln Industrial Corporation
hereby declares that the partly completed
machinery stated below:
Name: Ejectors
Model number(s):
Description:
Year of CE:
in its intended use, is in conformity with the
relevant union harmonization legislation:
Machinery Directive //EC
and conforms to the following harmonized
standards:
EN ISO :
Hydraulic fluid power - General rules and
safety requirements for systems and their
components
EN ISO :
Safety of machinery. General principles
for design. Risk assessment and risk
reduction
EN ISO :+A:
Pumps and pump units for liquids -
Common safety requirements
I, the undersigned of Lincoln Industrial Corporation, do hereby declare that the equipment specified above, in its intended use, conforms to
the requirements of the above EC Directive(s).
___________________________________
Robert Collins
Technical Compliance Manager
St. Louis, MO, U.S.A.
The following EHSR (Essential Health and
Safety Requirements) have been applied:
..a – ..b – ..c – .. – .. –
.. – .. – .. – .. – .. – ..
– .. – .. – .. – . – .. –
... - .. – .. – ... - ..
The manufacturer maintains a technical file
summary sheet containing test reports and
product documentation:
Technical file summary sheet number:
The partly completed machinery shown
above should not be put into service until the
final machinery into which it is to be
incorporated has been declared in conformity
with the provisions of the directive, where
appropriate.
, series “C”
Air operated
RA-
//
*
Indicates change.
To Next Page
Loading...
Need help?
General
