)
adjusting screw controls the amount of output per cycle.
WARNING
Always read and follow the fluid and
solvent manufacturer’s recommenda-
tions regarding the use of protective
clothing and equipment.
WARNING
Do not exceed maximum air or fluid
working pressure of lowest rated system
component.
Failure to comply may result in seri-
ous bodily injury or property damage.
WARNING
Always check equipment for proper
operation before each use, making sure
safety devices are in place and operating
properly. Do not alter or modify any
part of the equipment as this may
cause a malfunction and result in seri-
ous bodily injury.
WARNING
Do not exceed the stated maximum
working pressure of the ejector or of the
lowest rated component in your system.
• Do not alter or modify any part of this
equipment.
• Do not operate this equipment with
combustible gas.
•
Do not attempt to repair or disassem-
ble the equipment while the system is
pressurized.
• Tighten all fluid connections securely
before using this equipment.
• Always read and follow the fluid man-
ufacturer’s recommendations regard-
ing fluid compatibility, and the use of
protective clothing and equipment.
• Check all equipment regularly and
repair or replace worn or damaged
parts immediately.
Failure to heed these warnings including
misuse, over pressurizing, modifying
parts, using incompatible chemicals and
fluids, or using worn or damaged parts,
may result in equipment damage and/or
serious personal injury, fire, explosion,
or property damage.
Owner/operator
manual
It is the responsibility of the owner/operator
to properly use and maintain this
equipment.
The instructions and warnings contained
in this manual shall be read and understood
by the owner/operator prior to operating this
equipment.
It is the responsibility of the owner/opera-
tor to maintain the legibility of all warning
and instruction labels.
The owner/operator shall retain this
manual for future reference to important
warnings. Operating and maintenance
instructions.
Model : Used specifically with petro-
leum based materials.
Specifications
Priming pressure , psi ( bar) maximum
Air operating pressure psi (, bar) maximum
Output per cycle
)
. to . in
(, to , cm
)
Ratio :
Adjustment rate . in
/turn (, cm
/turn)
Maximum air required/cycle in
( cm
)
Wetted parts Carbon steel body, fluorocarbon, and nitrile
To Next Page
Loading...
Need help?
General
