Need help?Do you have a question about the Lincoln SKF P653S and is the answer not in the manual?
General| Brand | Lincoln |
|---|---|
| Model | SKF P653S |
| Category | Water Pump |
| Language | English |
Explains the meaning of NOTE, CAUTION, WARNING, and DANGER symbols.
Provides guidelines for safe installation, operation, and maintenance.
Details requirements for authorized personnel and handling defective parts.
Outlines regular checks and lubricant refill for the pump.
Defines intended use, lubricant compatibility, and pump features.
Lists available reservoir capacities and electrical connection requirements.
Explains the coding system for pump models, reservoir, and options.
Details power supply options and electrical cord/connector types.
Describes PCB settings for pressure switch or transducer selection.
Describes the internal components like motor, gear drive, pump elements, and vent valve.
Explains how the pump operates to build pressure and deliver lubricant.
Details pressure settings, holding times, and vent cycle for internal switch only.
Explains pressure settings and holding times with dual switches.
Covers pressure settings and holding times for internal transducer.
Describes the process of venting pressure back to the reservoir.
Guides on filling the reservoir and stirring paddle function.
Steps to remove trapped air from the follower plate during filling.
Explains how reservoir fill levels affect the low-level switch.
Details keypad functions and the initial display test.
Explains display codes related to operating status and settings.
Guides on setting pause times (P1, P2) and selecting start mode (SP/SO).
Explains setting alarm relay outputs (P4, P5) and transducer thresholds (P7, P8).
Covers fault signal displays (E1-E4), their meanings, and initial actions.
Identifies common failure modes and their corresponding solutions.
Provides a list of recommended lubricants based on testing and manufacturer data.
Presents wiring diagrams for 24V and 110-230V AC pump configurations.
Explains the function of jumpers on the PCB for various settings.
Illustrates the overall system layout including the pump and injectors.
Shows exploded views and lists part numbers for pump components.
Provides a template for mounting the pump.
Provides detailed measurements for different reservoir sizes (4L, 8L, 15L, 20L).
To Next Page