Service Training
Section 6
Page 46
6.4.5 PC connection for multifunction indicator settings
- All the operating parameters are stored in the multifunction indicator memory.
- The multifunction indicator is programmable by using the Linde parameterisation software, Truck
doctor version V1.1 P7 or later.
- Battery disconnected and contact cut-off
- Connecting the PC wire to the programming connector
for multifunction indicator 6X4
- Connect the battery
- Start Truck doctor
- Select "TNL - Dashboard" (p) in the main menu
https://www.besttruckmanuals.com/
To Next Page
Loading...
