P/N 1604010 Rev D (ECN 35207) 3-3 Multi-Control Operation Manual
Section 3 - Service
Alert Default Level Cause
High Rainfall Warning 2- Medium Rainfall accumulation in the rain bucket is nearing
the programmed limit.
Communication Warning 2- Medium FieldNET can communicate with the RTU but not
with the Multi-Control. This would indicate a loose
or severed serial cable connection.
Low pH Warning 2- Medium The pH limit is falling close to the programmed low
limit.
High pH Warning 2- Medium The pH limit is increasing close to the programmed
high limit.
Irrigating 3- Low The Multi-Control is irrigating.
Chemigating 3- Low The Multi-Control is chemigating.
Plan Paused 3- Low The current plan is paused.
Injector Off for Filter Flush Delay 3- Low Chemigation is temporarily stopped for a lter ush
cycle.
Filter Flush Cycle Running 3- Low The lter ush cycle is running.
Powered Off Normal 3- Low The Multi-Control is properly powered off.
Temperature Protection Plan Running 3- Low A temperature protection cycle is running.
Plan Running 3- Low The current plan is running.
Post-Filter Pressure Delay 3- Low The post-lter pressure alerts are temporarily being
ignored due to the system building up pressure.
Seasonal Maintenance
Start of Season
• Check for damaged wires and/or loose electrical connections. Contact a Lindsay Dealer for any wire replace-
ment.
• Make sure the solar panel is tilted to the optimum angle and direction for direct sunlight.
• Make sure the solar panel is clean.
• Remove debris from the rainfall collection bucket.
End of Season
• Store all rechargeable batteries in a cool, ventilated area, away from heat and open ame. Cover the battery
terminals to avoid accidentally creating a circuit due to exposed battery terminals.
• Turn off all wireless switches.
To Next Page
Loading...