5. Preset Bank Display - AMPLIFi FX100 contains 25 Preset Banks.
The Preset Bank Indicator shows the currently loaded Preset Bank,
as a number (1 - 25).
To Change Preset Banks: Changing Preset Banks requires that
you select a Bank, then load or save a Preset within that Bank. You
can select Preset Banks by pressing Preset Select Footswitches as
follows:
To Increment Through Banks: Press Preset Select Footswitches A
and B simultaneously.
To Decrement Through Banks: Press Preset Select Footswitches
C and D simultaneously.
Once you have selected the desired Bank, you can load or save
a Preset within the Bank by pressing the desired Preset Select
Footswitch.
Preset Status Indicator -Ifyouhavechangedanyamporeects
settings that are part of the Preset, a red dot will appear in the
bottom right of the Preset Bank Display. The dot will disappear after
the Preset has been saved or after a new Preset has been loaded.
6. Tap Tempo Button - Pressing the TAP Tempo button a few times
sets the tempo of Delays and other FX that synch to tempo.
Tuner Mode - Press and hold the TAP button for a few seconds
to enter Tuner Mode. When you play a note on your guitar, the
pedal will detect the closest pitch and display its value in the Bank
Display. The red LEDs on the left side of the Master Volume LED
Ringwilllightupwhenyournoteisat,andtheredLEDsonright
side will light up when it is sharp.When the top center LED is lit, your
note is in tune. Touch any footswitch or knob to exit Tuner Mode.
IN TUNE
Tuner LED Indicators
7. Expression Pedal - The LEDs to the left of the Expression Pedal
indicate when the Expression Pedal is engaged and active. The
pedal can toggle between Volume and Wah control via the pedal’s
integrated toe switch.
To toggle the Expression Pedal: Press the Expression Pedal all
the way forward to toggle the toe switch that lies under the top of
the pedal. Pressing the toe switch will toggle between Volume and
Wah control.
To Next Page
Loading...
Need help?
General
