Line 6 FLOOR POD User Manual

16. Footswitches
There are two footswitch modes; Channel Memory
and FX On/Off. To toggle between modes press and
hold the BYP footswitch for 1 second.
• Channel Memory Mode: The and
footswitches allow you to select a preset Channel
Memory. Scroll through Channel Memories by
pressing and holding one of these footswitches. The
BYP (bypass) footswitch does just that, bypassing all
amp models and effects - including the pedal.
• FX On/Off Mode: This mode allows you to turn
effects on and off within a preset. The DIST
footswitch turns a gain boost on and off, while MOD
and DLY turn the Modulation and Delay/Reverb
effects on and off respectively.
17. FX On/Off LED
This is only lit when you’re in FX On/Off mode. If it
is NOT lit, you know you’re in Channel Memory
mode.
18. Pedal
To toggle the pedal between Volume and Wah control,
press the pedal fully forward to click the toe-switch.
The Wah LED is lit when Wah effect is on. If it is
NOT lit, your pedal is controlling Volume.

Line 6 FLOOR POD Specifications

General

Power	9V DC Power Supply (Included)
USB	No
Type	Guitar Multi-Effects Processor
Inputs	1 x 1/4" (Guitar Input)
Outputs	1 x 1/4" (Headphone Output)
Controls	Drive, Bass, Mid, Treble, Channel Volume, Master Volume
Technology	Modeling
Footswitches	4