Controls & Connections
2• 6
1. When the S
AVE, EDIT or TUNE/SYSTEM button is lit, a scroll bar on the left side
of POD
XT’s display shows you where you are in the available display “pages.” Press
one of these buttons to see the scroll bar now. For those that really need to get all
the nerdy details, each dot in that bar represents a page. As you turn the S
ELECT
knob, you move through the pages and so does the little square. When you’re on
the first page, the little square is at the top. When you get to the last page, the
square’s at the bottom. Square goes up, square goes down. Square goes up, square
goes down. Fun for the whole family!
2. Each page typically has words that appear in the bottom of the display. These words
label things you can adjust. Press the button below the thing you want to adjust,
then turn the E
FFECT TWEAK knob to do your adjusting.
Soft Buttons - These four buttons operate differently depending on what
you’re doing. Generally, these allow you to instantly load one of 4 channels in a bank,
or get you in and out of Manual mode when you double-press (see S
ELECT above). If
the E
DIT, SAVE, or TUNE/SYSTEM button is lit, you can press a Soft Button to select
the item displayed above it so it can be adjusted with the E
FFECT TWEAK knob.
Effect On/Off Buttons - These four buttons allow you to quickly turn
any of the four effects on or off (the effects are on when the buttons are lit).
• The C
OMP (Gate) button turns on/off the loaded Compressor effect
• The S
TOMP button turns on/off the loaded Stomp-Box effect
• The M
OD button turns on/off the loaded Modulation effect
• The D
ELAY button turns on/off the loaded Delay effect.
Double-press one of these buttons to adjust the loaded effect or load a different one. For
example, just press the C
OMP button two times quickly and you’re instantly taken to
the Compressor and Gate E
DIT page. Double-pressing the STOMP button will quickly
take you to the first Stomp Box E
DIT page. Double-press the same button again (or
press the E
DIT button) to leave Edit Mode.
To turn off the built-in Noise Gate, double press the C
OMP button, then turn the
Threshold parameter all the way down.
18
19
PODxt Manual Book RevC.book Page 6 Friday, August 29, 2003 5:43 PM
To Next Page
Loading...
