13
System Utility Commands (Continued)
Timed Access Relay Latch
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for a period of hours.
1. Press
2. Enter the amount of time in hours (01-98) for the access relay to latch.
3. Press
Latch Access Relay
For servicing or testing, while in Programming Mode, the access relay
can be latched manually from the keypad for an indefi nite period of time.
✦ NOTE: This command will reset and override and timed access relay latch
set by PPN 80.
1. Press
Release Access Relay
For servicing or testing, while in Programming Mode, this command
will release the access relay if it has been manually latched (timed or
indefi nite).
1. Press
Delete All Directory Entries
This utility command will permanently erase all Directory Codes, Names,
Telephone Numbers, and resident’s Entry Codes.
CAUTION: This utility command will erase ALL the Directory Entries in the
unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press
again for verifi cation.
Delete All Stand-alone Entry Codes
This utility command will permanently erase all Stand-alone Entry
Codes.
CAUTION: This utility command will erase ALL the Stand-alone Entry
Codes in the unit.
✦ NOTE: This step cannot be performed remotely through the telephone.
1. Press
2. Press
again for verifi cation.
PPN 92
92#92#
DELETE ALL DIRECTORY ENTRIES
PPN 83
83#
RELEASE ACCESS RELAY
PPN 80
80#HOURS#
HOURS = RELAY LATCH TIME IN HOURS (01-98)
TIMED ACCESS RELAY LATCH
PPN 81
81#
LATCH ACCESS RELAY
PPN 93
93#93#
DELETE ALL STAND-ALONE ENTRY CODES
STANDARD PROGRAMMING METHOD
To Next Page
Loading...
Need help?
General
