To Next PageTo Next Page
Need help?Do you have a question about the Linear RE-1 and is the answer not in the manual?
General| Brand | Linear |
|---|---|
| Model | RE-1 |
| Category | Intercom System |
| Language | English |
Visitor and resident interaction for calls and access control.
Covers entry codes, transmitters, and local control capabilities.
Seven programmable time zones for scheduling system functions.
Includes anti-passback, keypad lockout, and portal supervision.
Wire type, size, and conduit requirements for telephone lines.
Instructions for proper grounding of the unit and bypass module.
Terminal blocks for power, relays, antenna, telephone, and grounds.
Diagram showing wiring for gate operator connection.
Diagram illustrating wiring for electric door strike or magnetic lock.
Explains the role and wiring of the Telephone Bypass Module.
Standard configuration using a shared telephone line.
Wiring details for controlling a gate operator via Relay #1.
Wiring for electric door strikes or magnetic locks using Relay #1.
Connecting the RE-1 to the power transformer and wire gauge requirements.
Proper grounding procedures for the RE-1 and bypass module.
Accessing programming via computer, keypad, or local telephone.
Accessing programming via a remote telephone or computer.
How to enter programming mode and navigate using keypad or phone.
Steps to call the RE-1 remotely and enter programming mode.
Keystrokes for entering/exiting programming and basic commands.
Reference table linking PPNs to programming functions and page numbers.
Table listing default settings for various system parameters.
How to enter and exit the programming interface using codes.
Process for adding up to 100 entry codes with relay and time zone assignments.
Assigning up to 100 transmitters into 24 groups with time zone privileges.
Visitor procedure for entering access codes and system responses.
Visitor procedure for using wireless transmitters for access.
Visitor procedure for initiating a call to the resident.
Resident commands to control relays and initiate voice communication.
Resident commands to control relays and disconnect from a remote phone.
Keystrokes to enter the system's programming interface.
Quick reference for adding entry codes, relay, and time zone settings.
