Linear AE-500 - Telephone and Radio Connectivity; Telephone Line Setup; Radio Antenna Installation and Tuning

11
Wireless Transmitter Programming (Continued)
Activate a Transmitter
If a transmitter has been suspended, it can be activated again with these
programming steps.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press
3. Enter the transmitter’s facility code (enter 0 if not used).
4. Press
5. Enter the transmitter’s ID number.
6. Press
7. Exit Programming Mode if all programming is complete.
Delete single Enrolled Transmitter
Delete a single enrolled transmitter from the system.
1. If not alreay in Programming Mode, connect by telephone or use the local
keypad. Enter the master password and access programming.
2. Press
3. Enter the transmitter facility code.
4. Press
5. Enter the transmitter ID number of the transmitter.
6. Press
7. Exit Programming Mode if all programming is complete.
PPN 42
42#FC#ID#
FC = FACILITY CODE 0-15 (0 IF UNUSED)
ID = TRANSMITTER ID NUMBER
ACTIVATE A TRANSMITTER
PPN 47
47#FC#ID#
FC = FACILITY CODE (0 IF UNUSED)
ID = TRANSMITTER ID NUMBER
DELETE SINGLE ENROLLED TRANSMITTER