7
The opener is supplied with a three-button remote control (the second and third buttons can be used to
control an additional openers or gates). Additional single and multi-button remote controls can be purchased.
The short wire on the back of the opener serves as an antenna for the remote controls. Do not cut off the wire
or the remote controls will not operate well.
To Add or Remove a Remote Control
1 Press the opener’s LEARN button. The opener’s
light and red light will ash once and turn on for
about 15 seconds. A remote control must be
added or removed while the red light is still on.
2 Press the remote control button you want to
program. The opener’s light and the red light
will ash once if a remote control was added, or
the opener’s light and the red light will ash four
times if a remote control was removed.
3 Repeat Steps 1 & 2 for any additional remote
control controls.
To Remove All Remote Controls
CAUTION: This will remove ALL transmitters and
keypad codes from the operators memory.
1 Press and hold the opener’s LEARN button for
ten seconds or more.
2 Release the LEARN button. The red light and
opener’s light will blink three times signaling that
all of the remote controls in the opener’s memory
were erased. The red light will turn off, then turn
on for 15 seconds. A remote control can be
entered during this time using the steps above.
Testing
1 Before testing the remote control, straighten out the opener’s antenna wire so it points up.
2 Stand clear of the door, press the remote control’s button and verify that the opener starts. PRESS THE
REMOTE CONTROL’S BUTTON AGAIN TO STOP THE DOOR MID-TRAVEL.
Replacing a Remote Control’s Battery
When the red light on the remote control glows dimly, or
fails to light at all when the remote control is activated,
the battery needs replacing.
Follow the steps in the diagram and use caution to keep
batteries away from children.
Replace old battery with a fresh CR2032 Lithium battery.
Properly dispose of old batteries. Many electronic stores
and supermarkets have battery recycling bins.
Never dispose of batteries in re because they could
explode.
PROGRAMMING REMOTE CONTROLS
4 5
6
1 2 3
USE COIN OR VISOR
CLIP IN SLOT TO
OPEN CASE
REPLACING THE REMOTE CONTROL BATTERY
CARFULLY REMOVE
THE BOARD
LIFT OFF TOP
OF CASE
REMOVE OLD
BATTERY AND
DISPOSE OF
PROPERLY
INSERT NEW
CR2032
BATTERY
PLUS SIDE UP
RE-ASSEMBLE
REMOTE CONTROL
SEND A SIGNAL
FROM A REMOTE
THE OPERATOR'S LIGHT AND
RED LIGHT WILL FLASH ONCE IF A
REMOTE IS ADDED, THE OPERATOR'S
LIGHT AND THE RED LIGHT
WILL FLASH FOUR TIMES
IF A REMOTE IS REMOVED
1
2
ADDING OR REMOVING A REMOTE
PRESS THE LEARN BUTTON
FOR 10 SECONDS OR MORE
1
2
REMOVING ALL REMOTES
THE RED LIGH
AND OPERATOR’S LIGH
T
WILL BLINK 3 TIMES
SIGNALING THAT
ALL REMOTES
WERE REMOVED
To Next Page
Loading...
Need help?
General
