13. FAQ 14. Notice
Q1: Camera turns ON / OFF automatically?
Ensure that the output current can reach 5V/1.5A and use our car charger.
Q2: Video Image is blurred?
Remove the protective lens film, clean the lens, make sure the windshield is
clean and clear of grease, dirt, and debris.
Q3: Camera gets HOT?
It is normal for your camera to run slightly hot. Due to video being recorded
at high speed, the dash cam may be hot during using.
(No more than 158°F/70ºC).
Q4: Video Files cannot be played on my computer?
The video files from the Dash Cam are in MP4 format and may not be
compatible with your PC if suitable playback software is not installed.
Q5: Video has no sound?
Ensure that ‘Audio Recording’ setting is turned ON.
Q6: Video is blurred?
The Dash Cam has a minimum focal range of around 2 meters.
Objects closer than this are likely to become blurred.
Q7: Voice prompt Memory Error?
Using unqualified SD or third party cards can affect dashcam's
performance and in some cases, force the dashcam to reboot randomly
during recording. If it still can not work normally, it should be that the TF
card is unqualifiedand can not meet the recording requirements of the
dash cam. Please contact us to get a new memory card.
This product complies with the radio interface requireme-nts of the
European Community.
This symbol means the product must not be discarded as household
waste, and should be delivered to an appropriate and recycling helps
protect natural resources, human health and the environment. For more
information on disposal and recycling of this product, contact your local
municipality, disposal service, or the shop where you bought this product.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
EN-37 EN-38
To Next Page
Loading...