Install the front camera behind the rear view mirror.Remove any foreign
matter and clean and dry the windshield before installation.
1. Turn off the engine, gently push the card into the slot until it locks into
place.(Please using class 10 or above high-speed U3 micro-SD card)
2. Find a suitable place on windshield where don’t obstruct the driver’s
field of vision and remove any foreign matter and clean and dry the
windshield before installation.Tear off the protective layer of the
electrostatic sticker and adhere the electrostatic sticker to the windshield
to prevent mark/glue on your windshield after removing it.
3. Peel off the protective film from the double-sided tape and attach the
front camera to the electrostatic sticker.Adjust the angle of the lens by
rotating the body of the front camera.
4. Plug the cigarette lighter power cable into the cigarette lighter socket
and the front camera.Use the pry tool to lift the edges of the windshield
trim/molding and tuck in the power cord.
7. Installation
Charging cable
EN-11 EN-12
To Next Page
Loading...