10
3.3. After opening the control software to connect to the serial port, set Add info to ON state. Each display unit displays
the corresponding address and other information as follows:
3.4. Set Splice to the on state, hold down the left mouse button and drag inside the software interface to create a window
similar to the estimated coordinates and length and width, as shown below:
3.5, Use the right mouse button to click the dragged window, the following interface pops up, and the ID
address is modified to the ID corresponding to the display unit in the interface. Each display unit needs to
be configured with the corresponding address to control.(The following is a description of each button on
the popup interface).
The display unit now looks like the following image:
To Next Page
Loading...
Need help?
General