960-3100-00 iPonic 614 Installation Manual 33
Administrative Settings
View Model Number and Firmware Versions
Menu->SystemSetup->6. Advanced-> More->button 2 for Controller Version
Upgrade/Restore Controller Firmware
Insert USB into port inside the controller case.
Menu->SystemSetup->6. Advanced-> More->button 4 for Bootload(have USB in)
Password Protect Controller
Menu->SystemSetup->6. Advanced-> More->button 5 for Password->Add Password
To Save/Restore/Delete a Controller Configuration
Insert USB into port inside the controller case.
Menu->Save/Restore Config->button 1 to Save, button 2 to Restore, button 3 to Delete
Adjust the Backlight and Button Light Time Lengths
Menu->SystemSetup->6. Advanced-> More->button 1 for Time Setting choose BackLight or ButtonLight
and adjust number of seconds, adjust to zero to maintain off
Clear/Reset Setpoint and Sensor History
Menu->SystemSetup->6. Advanced-> More->button 3 for Clear Data->button 1 for Clear History
Restore Factory Defaults
Menu->SystemSetup->6. Advanced-> More->button 3 for Clear Data->button 3 for Restore Factory
Defaults
Change Date/Time
Menu->SystemSetup->5. Time/Date Setup->button 1 to set time, button 2 to set date
Rerun Startup Wizard
Will prompt you to enter the date and time, equipment types and the CO
2
equipment type, if one is
selected.
Menu->SystemSetup->6. Advanced-> More->button 6 for Start Wizard Enable, then Y/N rerun wizard
Sensor Report
View minimum and maximum temperature, humidity and CO
2
reading since last reset and in last 24
hours.
Menu->Reports->1. Sensor Report->button 1 or 4 to toggle between “Since Reset” and “Last 24 Hours”
Setpoint and Sensor Tracking
Humidity Setpoints and also the measured temperature, humidity, light and CO
2
detected since last reset,
in the last hour, in the last 24 hours or in the last 7 days.
Menu->Reports->2. Graphs->(choose condition)->(choose setpoint or sensor data to graph)->Press OK
to generate and view graph
Map Individual Sensors
Menu->SystemSetup->SensorSetup->button 2 for Advanced->button 1 to choose sensor to map
Calibrate Individual Sensors
Menu->SystemSetup->SensorSetup->button 2 for Advanced->button 2 to calibrate by entering
adjustment value
Format File System
Menu->SystemSetup->6. Advanced-> More->button 3 for Clear Data->button 2 to format file system
Save Log Files
Insert USB into port inside the controller case.
To Next Page
Loading...
