960-3100-00 iPonic 614 Installation Manual 32
7. Keep cables away from interference sources, including high voltage power wiring, inverters, motor
controllers, mercury arc, or sodium lamp circuits.
8. Connect the wires as shown in Figure.
9. Make sure you test the
Sensaphone by programming a high and low limit (if both relays are used; either if
one relay is used) and then make the alarms go off to see if the Sensaphone will contact the right number.
After testing remember to unplug the iPonic
TM
614 before continuing to install other equipment.
10. Refer to the Sensaphone installation instructions for programming the unit.
To Next Page
Loading...
