Linksys E1200 - Page 19

Field Electronics Setup Guide FTC_PIT
Rev 10 1/23/2013 18 ©2012 FIRST Tech Challenge
3.6. After saving settings:
3.6.1. Open Start > Programs > Accessories and select “Command window.”
At the prompt, type:
Ipconfig /release <press enter> : The following screen should appear showing your IP address 0.0.0.0: (It may take
a minute)
Ipconfig /renew <press enter> The following screen should appear showing your that your IP address is in the
192.168.1.1xx range (Note: it may take a minute for the command to complete).
Default setting
Change this to a 2