FCC Statement
This device complies
with
Part 15
of
the FCC Rules. Operation
is
subject
to
the
following
two
conditions:
(1)
This device may
not
cause harmful interference, and (2) this device
must
accept
any interference received, including interference
that
may
cause undesired operation.
This product has been
tested
and complies
with
the
specifications
for
a Class B digital device, pursuant
to
Part 15
of
the FCC Rules. These limits are designed
to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and,
if
not
installed and used
according
to
the
instructions, may cause harmful interference
to
radio communications. However, there is
no
guarantee
that
interference will
not
occur in a particular installation.
If
this
equipment does cause harmful interference
to
radio
or
television reception, which is found
by
turning
the
equipment
off
and on, the
user
is encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the following measures:
• Reorient
or
relocate
the
receiving antenna.
• Increase
the
separation between the equipment and devices.
• Connect
the
equipment
to
an
outlet
other
than
the receiver's.
• Consult a dealer
or
an experienced radio/TV technician
for
assistance.
FCC Caution: Any changes
or
modifications
not
expressly approved by the
party
responsible
for
compliance could void the
user's authority
to
operate
this
equipment.
2.4GHz
operation
of
this
product
in
the
USA
is firmware-limited
to
channels 1 through
11.The
device
for
the
band
5150-
5250
MHz
is only
for
indoor usage
to
reduce
the
potential
for
harmful interference
to
co-channel mobile satellite systems.
Mexico Regulatory
Statement
La operacion de este equipo esta sujeta a las siguientes dos condiciones:
(1)
es
posible que este equipo o dispositivo no
cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operacion no deseada.
FCC Radiation Exposure
Statement
This equipment complies
with
FCC radiation exposure limits
set
forth
for
an uncontrolled environment. This equipment
should be installed and operated
with
minimum distance
35
cm
between the radiator and your body.
This device and it's antennas(s)
must
not
be co-located
or
operating in conjunction
with
any
other
antenna
or
transmitter
except in accordance
with
FCC multi-transmitter product procedures.
Restrictions in
the
5 GHz Band
The device
for
the band
5150-5250
MHz is only
for
indoor usage
to
reduce potential
for
harmful interference
to
co-channel
mobile satellite systems.
This device has been designed
to
operate
with
an antenna having a maximum gain
of
2.53
dBi and
3.37
dBi
at
2.4
GHz
and 5 GHz respectively. Antenna having a higher gain is
strictly
prohibited per regulations
of
Industry Canada. The required
antenna impedance
is
50
ohms.
The maximum antenna gain (Please see the table below) permitted (for devices in
the
bands
5250-5350
MHz
and
54
70-
5725
MHz)
to
comply
with
the
EIRP limit and because high power radars are allocated as primary users (meaning they
have priority) in
5250-5350
MHz
and
5650-5850
MHz
, these radars could cause interference and/or damage
to
license
exempt LAN devices.
To Next Page
Loading...
