Linksys LGS116P User Manual

FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR ELEC-
TROMAGNETIC COMPATIBILITY
We, LINKSYS of 131 Theory, Irvine, CA 92617, declare under our sole
responsability that the products to which this declaration relates, comply with Part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This product has been tested and complies with the specifications for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver’s
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this
equipment.
Mexico Regulatory Statement
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es
posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este
equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operación no deseada.
EAC Mark of Conformity for Russia, Kazakhstan and
Belarus

Linksys LGS116P Specifications

General

Switch type	Unmanaged
Switch layer	-
Quality of Service (QoS) support	Yes
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
10G support	No
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Throughput	1.488 Mpps
MAC address table	8000 entries
Input current	1.66 A
Power consumption (typical)	11.31 W
Number of power supply units	1
Certification	FCC Class A, CE
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Total Power over Ethernet (PoE) budget	80 W
Power over Ethernet plus (PoE+) ports quantity	8

Weight and Dimensions

Depth	120 mm
Width	280 mm
Height	25 mm
Weight	822 g