VoiceDirector Device Configuration Guide Linksys PAP2
1. Linksys PAP2
This guide contains VoiceDirector configuration instructions for the Linksys PAP2
device.
STEP 1 – SETUP ACCOUNT
Make sure you have an account on the VoiceDirector server to which you are
connecting.
STEP 2 – ACCESSING THE PAP2
Connect an analog phone to the RJ-45 connector on the PAP2.
1. Using the telephone keypad, press the star key (*) four (4) times: ****.
You will be prompted to enter a code.
2. Enter the code 110 followed by the pound key (#).
The system announces the IP address. Write it down.
STEP 3 - LOGGING INTO THE WEB CONFIGURATION
INTERFACE
To log into the WRP200’s Web Configuration Interface:
1. Launch Microsoft© Internet Explorer.
2. In the Address bar, enter http://, followed by the IP address you wrote
down in step 3 above.
For example, if your IP address is 192.168.1.100 you would enter
http://192.168.1.100 in the Address bar.
3. Press the Enter key on your keyboard, or click the Go button.
The status screen displays. You are now logged into the PAP2’s Web
Configuration Interface.
Page 1
To Next Page
Loading...
Need help?
General
