2224 Layer 2 Management 24-Port 10/100 Ethernet Switch
n
nect II 2224
2. Use the Down Arrow key to highlight Rate Control and press the Enter
key. The Rate Control Status screen appears.
3. Highlight the desired setting, then press the Enter key. Your selection
appears next to Rate Control in the Rate Control screen.
4. To change the port number setting, press the Down Arrow key to high-
light Port Number, then press the Enter key. The Port Number screen
appears.
5. Highlight the desired port number, then press the Enter key. A screen
showing the average rate and traffic type settings for the selected port
appears.
101
ProConnect II
®
Series
Note
Fixed Drop Priority and Fixed Transmit Priority are read-only parameters that
cannot be changed.
4. Press the Esc key until you return to the desired screen.
Selecting Rate Control Parameters
To specify rate control parameters:
1. From the QoS screen, use the Down Arrow key to highlight Rate Control,
and then press the Enter key. The Rate Control screen appears.
100
To Next Page
Loading...
