Linksys Velop WHW03 User Manual

17
•
Reboot your Velop.
•
Contact your ISP and ask about outages in your area.
The most common method of troubleshooting your Velop is to turn it off, then back on again. Your Velop
can then reload its custom settings, and other devices (such as the modem) will be able to rediscover
the Velop and communicate with it. This process is called rebooting.
To reboot your Velop using the power cord, do the following:
1. Disconnect the power cord from the Velop and the modem.
2. Wait 10 seconds, and reconnect the power cord to the modem. Make sure it has power.
3. Wait until the modem’s online indicator has stopped blinking (about two minutes). Reconnect
the power cord to the Velop.
4. Wait until the LED on top of the Velop is solid blue. Wait two minutes before trying to connect
to the internet from a computer.
To reboot your Velop using the Linksys app, do the following:
1. Launch the app.
Under
Velop Administration , click Restart Velop.

Linksys Velop WHW03 Specifications

General

Wi-Fi Technology	802.11ac
Coverage	Up to 2, 000 sq ft per node
Processor	716 MHz Quad-core
Security	WPA2 Personal
MU-MIMO	Yes
Beamforming	Yes
Guest Access	Yes
Parental Controls	Yes
Dimensions	3.1 x 3.1 x 7.3 inches per node
Maximum Data Transfer Rate	2200 Mbps
Memory	512 MB RAM, 4 GB flash
Ports	2x Gigabit Ethernet ports
Wi-Fi Speed	AC2200 (867 + 867 + 400 Mbps)
Wi-Fi Bands	2.4 GHz and 5 GHz
Antennas	6 internal antennas
Product Type	Mesh Wi-Fi System
Number of Nodes	1, 2, or 3 nodes
Coverage Area	Up to 6, 000 sq ft with 3 nodes
Compatibility	Works with any modem