Linksys WAP300N - Page 13

2. Enter Wi-Fi Protected Setup PIN from the Client Device on WAP300N
- Enter the client’s PIN number in the field on this screen.
- Click Register.
- After the client device has been configured, click Close.
3. Enter Wi-Fi Protected Setup PIN from WAP300N on the Client Device
- On the client’s Wi-Fi Protected Setup screen, enter the PIN number listed on WAP300N’s Wi-Fi
Protected Setup screen. Then click Register or the appropriate button on the client device’s Wi-Fi
Protected Setup screen. (The PIN number is also listed on the label on the bottom of the Access Point.)
- After the client device has been configured, click Close.
Regardless which method was used, the Wi-Fi Protected Setup Status, Wireless Band, Network Name
(SSID), and Security mode are displayed at the bottom of the screen.
Manual Setup