In RC1 firmware, there is no 5Ghz and 2.4Ghz wireless settings string in left side.
Local Wi-Fi MAC Address
The Wi-Fi MAC address of this device is displayed here.
Remote Wireless Bridge’ Wi-Fi MAC Addresses
Enter the Wi-Fi MAC addresses of other WAP300N units (also in Wireless Bridge mode) you want this
device connects to.
Wireless Band
This is used to select the 2.4 GHz or 5 GHz radio band. The 5 GHz band is much less crowded than the
2.4 GHz band, so it is more likely that you will have your own interference-free channel.
Channel Width
To Next Page
Loading...
