Linksys WAP300N - Wireless Security Configuration

For best performance in a Wireless-N network, select 40MHz only (only available in 5 GHz radio band) or
Auto. In Auto mode, this device and other WAP300Ns connected to this device automatically switch to
the 40 MHz mode if there is no adjacent interference.
Channel
Choose the operating channel for your wireless network. This device will automatically select the
channel with the least amount of interference if you leave the default Auto setting. Keeping the default
setting Auto is recommended.
IMPORTANT: When WAP300N is set to Wireless Bridge mode, this device will communicate only with
other WAP300N unit(s) that is/are also in Wireless Bridge mode. In addition, all wireless settings,
including wireless band, channel, channel width, security mode and security passphrase/key, are also
required to be the same on all the networked WAP300N units.
Wireless > Wireless Security
This screen is only available when the device is in Access Point mode and Wireless Bridge mode.
(In Wireless Media Connector mode or Wireless Range Extender mode, wireless security is set up via
Wireless > Basic Wireless Settings.)