12 Volt Power Over Ethernet Adapter Kit
7
Chapter 2: Getting to Know the 12 Volt Power Over Ethernet Adapter Kit
The Splitter
The Splitter
The Splitter’s built-in cables and port are located on side panels.
The Splitter’s First Side Panel
The Power & Data IN port is located on the Injector’s first side panel.
Power & Data IN This port allows you to connect the Splitter to the Injector. (You will use the included
Ethernet network cable to make this connection.)
The Splitter’s Second Side Panel
The built-in Ethernet network and Power cables are located on the Splitter’s second side panel.
Ethernet OUT The Splitter has a built-in Ethernet network cable. You will connect this cable to the
Ethernet network port of your remotely located access point or other network device.
Power The Splitter has a built-in power cord. You will connect this cord to the Power port of your
remotely located access point or other network device.
Figure 2-4: Splitter’s First Side Panel
Figure 2-5: Splitter’s Second Side Panel
To Next Page
Loading...
Need help?
General
