22
Chapter 5: Configuring the Wireless-G Broadband Router
The Wireless Tab - Wireless Security
Wireless-G Broadband Router with SRX200
WEP. WEP is a basic encryption method, which is not as secure as WPA or WPA2. To use WEP, select a Default
Transmit Key (choose which Key to use), and a level of WEP encryption, 64 bits 10 hex digits or 128 bits 26 hex
digits. Then either generate a WEP key using the Passphrase or enter the WEP key manually.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes. For detailed instructions on configuring wireless security for the Router, turn to
“Appendix B: Wireless Security.”
Figure 5-20: Wireless Tab - Wireless Security (WEP)
IMPORTANT: If you are using wireless security, always remember that
each device in your wireless network MUST use the same wireless security
method and shared key, or else the network will not function correctly. You
may mix between WPA and WPA2 Personal or WPA and WPA2 Enterprise,
but not between Personal and Enterprise, Personal and WEP, or Enterprise
and WEP.
To Next Page
Loading...
Need help?
General
