40
Chapter 5: Configuring the Wireless-G Broadband Router
The Status Tab - Local Network
Wireless-G Broadband Router with SRX200
The Status Tab - Local Network
The Local Network screen on the Status Tab displays the status of your network.
Local Network
MAC Address. This is the Router’s MAC Address, as seen on your local, Ethernet network.
IP Address. This shows the Router’s IP Address, as it appears on your local, Ethernet network.
Subnet Mask. When the Router is using a Subnet Mask, it is shown here.
DHCP Server. If you are using the Router as a DHCP server, that will be displayed here.
Starting IP Address. For the range of IP Addresses used by devices on your local, Ethernet network, the
beginning of that range is shown here.
Ending IP Address. For the range of IP Addresses used by devices on your local, Ethernet network, the end of
that range is shown here.
DHCP Client Table. Clicking this button will open a screen to show you which PCs are utilizing the Router as a
DHCP server.
Click the Refresh button to update the on-screen information. Help information is shown on the right-hand side
of the screen.
Figure 5-42: Status Tab - Local Network
Figure 5-43: DHCP Active IP Table
To Next Page
Loading...
Need help?
General
