You may need to fully charge the battery on the control device before
continuing with this procedure (see the information supplied with the
control device), this may take an hour or longer.
1. Update the control device with .NET 2.0, available at
www.microsoft.com/net.
2. Copy the Linn GUI installer to the wireless control point.
3. Copy the Linn Config installer onto the installation PC/laptop.*
4. Run both the installers. Do not launch the Linn GUI or Linn Config
at this time.
5. On the wireless control point, disable the ‘Auto Right Click’
behaviour. This can be done by locating the notification area at the
bottom-right of the Windows screen, and clicking the Touchkit: USB
Controller icon
• Select the Setting tab
• Press the Option button
• Deselect ‘Enable Auto Right Click’.
6. You must give the installation PC/laptop’s firewall permissions for
the Linn Config and Linn GUI to access the network.
If the owner uses the Windows Firewall, follow the instructions from
the following link to add Linn Config and Linn GUI.
http://www.microsoft.com/windowsxp/using/networking/security/
winfirewall.mspx
6 THE WIRELESS CONTROL POINT, AND INSTALLING
THE LINN GUI AND CONFIG APPLICATION
www.linn.co.uk
AKURATE DS SYSTEM
INSTALLATION AND SETUP
22
If they use a different firewall, consult the vendor’s manual for
instructions.
Note:
If you update the Akurate DS system with new Linn Config or Linn GUI
software, you must add the new software to the firewall permissions.
7. To configure you Akurate DS system, follow the instructions in The
Linn Config Application section.
* You may wish to install the Linn Config on the PC/laptop the
customer will use to rip CDs. This would mean the customer will
be able to make changes to their system’s setup (e.g. add a new
source), and run the diagnostic tools, should their be a problem.
To Next Page
Loading...
Need help?
General
