Connecting to the mains supply
The Akurate DS contains an automatic internal mains voltage
switch. This switch operates on all worldwide mains voltages from
100 V to 240 V. The unit can be connected to any worldwide mains
voltage with no adjustment.
This unit must be earthed. Use the earthed moulded mains lead
supplied, or if no mains earth is available, ensure the product’s
EARTH GROUND connector is connected to an earthing terminal.
7 AKURATE DS INSTALLATION (continued...)
www.linn.co.uk
AKURATE DS SYSTEM
INSTALLATION AND SETUP
RS232 connection on the Akurate Kontrol
For communication to take place between the components in an Akurate DS
system, the RS232 Setup settings must be correctly configured on the
Akurate Kontrol.
The correct RS232 Setup settings are.
Baud Rate: 9600
Parity: Even
Data Bits: 7
Stop Bits: 1
RS232 Events: Enabled
To access the setup menus:
Using the handset -
• Press AMP, then SETUP on the handset.
Using the front panel -
• Hold SELECT on the front panel until MAIN MENU / SPEAKER SETUP
is shown on the display.
To navigate through the menus and options:
• Use the / keys on the handset or front panel.
To make a selection:
• Press on the handset, or SELECT on the front panel.
To exit the setup menus:
• Press SETUP on the handset, or select EXIT from the MAIN
MENU (if changes have been made you will be prompted to save or not
save the changes).
25
To Next Page
Loading...
Need help?
General
