5. The ‘Ethernet’ screen
Select the IP address assignment appropriate for the network the
Akurate DS system is being installed into. Press ‘Apply’, then ‘Next’.
6. The ‘Global Network Settings’ screen
Select a hostname for the NAS, e.g. ‘nas001’. This name
should be unique to the network. This name will be used to refer
to the NAS from other devices on the network, for example the
ripping software (please refer to the EAC Installation section for
details). Leave other settings unchanged. Press ‘Apply’, then ‘Next’.
7. The ‘Admin Password’ screen
Complete the required information. Press ‘Apply’, then ‘Next’.
8. The ‘Security Mode’ screen
Nothing on this screen needs changed. Press ‘Next’.
2 SET UP OF THE NAS (continued...)
www.linn.co.uk
AKURATE DS SYSTEM
INSTALLATION AND SETUP
4
4. The ‘Alerts’ screen
Enter one or more service email contacts. If there are any problems
with the NAS, email notification will automatically be sent from the
NAS. This allows the problem to be diagnosed and corrective
action taken before the user is aware that a problem exists. Press
‘Apply’, then ‘Next’.
3. The ‘Clock’ screen
Select the appropriate timezone and time for your location. If the
‘Synchronize clock…’ checkbox is selected, deselect it. Press
‘Apply’, then ‘Next’.
To Next Page
Loading...
Need help?
General
