10
TURNTABLES For best results a turntable should be placed on a small, light, rigid table, or alternatively
wall mounted on a light, rigid shelf.
POWER SUPPLIES Take care not to position too close to signal leads, turntables or pre-amplifier.
AMPLIFIERS Pre and power amplifiers may hum if positioned too close together. For minimum hum
experiment by moving the components with the system at full volume but not playing music (although it is
best to turn the volume down whilst actually moving the components).
LOUDSPEAKERS Loudspeakers should be positioned correctly. They should be mounted on rigid
stands and not subject to any rocking movement. All Linn speakers except NEXUS and HELIX are
designed to be placed very close to the wall.
CLEAN CONTACTS lt is important that the electrical contacts in a hi-fi system are kept mechanically
sound and clean. Occasionally unplugging and replugging all the connectors will effectively clean
contacts,
WARNING This should be carried out after the mains supply has been switched off.
INTERCONNECT LEADS Correct cables should be used. We recommend good quality copper cable
for interconnect leads and advise 4mm
2
multicore copper cable, such as Linn K20 for speaker leads.
Your Linn dealer can supply high quality interconnects for linking all your hi-fi components.
To Next Page
Loading...