9
The KELTIK AKTIV system is pre-set at the factory for an accurate on-axis frequency response and this
will suit most environments. However, the bass and/or treble may require adjustment to suit some
rooms. A resistor pack is provided with the product to allow the dealer to carry out any necessary
adjustments at installation. ON NO ACCOUNT SHOULD THIS BE ATTEMPTED BY THE USER.
OPERATION The KELTIK AKTIV has no operational controls, apart from the on/off switch. It will be
correctly set to suit your listening environment by the Linn dealer on installation, and needs no further
adjustment. If you move the system to another room, or move house, your Linn dealer will be pleased
to advise on transfer and set it up in the new position.
LOUDSPEAKER GRILLE The KELTIK loudspeaker grille is unusual in that it has no frame and fits
directly onto the front baffle. This avoids the problem of rattling and diffraction, which a frame can
introduce.
Fitting the grille is time consuming, so unless you want to use the speaker without the grille, it is best to
leave it on. If you have to refit the grille, make sure you locate the knotted part of the elastic in the slot
below the bass driver, before fitting the top part of the grille.
The grille can be removed by gripping the top right corner, pulling it so that the elastic clears the baffle,
then gradually removing the rest.
To Next Page
Loading...