6
Label all the cables at installation to avoid errors. Double check all connections, especially loudspeaker
phase, before powering up for the first time.
NOTE When using a Linn pre-amplifier, connect the positive output of the power amplifier to the
negative loudspeaker terminal, and the negative output to the positive loudspeaker terminal, as Linn pre-
amplifiers invert the signal phase to their main output. It is best to connect positive to positive, negative
to negative on the speaker outputs of the power amplifiers and connect positive to negative, negative to
positive on the backs of the loudspeakers. It is generally easier to see the backs of the loudspeakers
to check the installation.
The leads provided allow for the KELTIK AKTIV to be sited a short distance from the pre-amplifier and
power amplifiers, if this does not suit your installation, your dealer can supply the necessary length of
cable.
NOTE When using Linn LK280s in the KELTIK system, the bass amplifier protection trip should be
modified by your dealer.
To Next Page
Loading...